中圖分類號： TM832 文獻(xiàn)標(biāo)識碼： A DOI：10.16157/j.issn.0258-7998.201266 中文引用格式： 袁松，曾敏，李陽，等. 諧振高壓等離子球磨電源研究[J].電子技術(shù)應(yīng)用，2021，47(9)：91-95. 英文引用格式： Yuan Song，Zeng Min，Li Yang，et al. Research on resonant high voltage plasma ball milling power supply[J]. Application of Electronic Technique，2021，47(9)：91-95.
Research on resonant high voltage plasma ball milling power supply
Yuan Song，Zeng Min，Li Yang，Hu Zixin
School of Mechanical & Automotive Engineering，South China University of Technology，Guangzhou 510641，China
Abstract： Plasma assisted ball milling technology requires high voltage power supply to excite the plasma field. However, high voltage plasma ball milling power supply has many problems such as large numbers of switch tubes, complicated control timing, and low reliability. Therefore, the high voltage plasma ball milling power supply based on single tube structure has been developed. Firstly, the working principle of the main circuit is introduced, and the inherent resonance frequency and resonance parameter selection of the primary resonance network are analyzed in detail. In addition, the voltage gain of the transformer and load series resonance network is utilized to further increase the amplitude of output voltage. Through Simulink software, the main circuit waveforms and the resonance voltage gain are verified. The peak-to-peak output voltage reach more than 24 kV. Based on the above, a prototype with an output power of 3 kW is developed, and the plasma field is successfully excited and used in auxiliary field ball milling.
Key words : silicon controlled rectifier；auxiliary field ball milling；high voltage power supply；resonance；plasma
